Cell loading system
The loading and unloading system is a really well-known transportation way in the contemporary logistics. It is a bridge connecting the organization logistics chain, and also a loading and unloading procedure platform for enterprises to quickly and safely and securely transportation the merchandise and products. The top of the platform can not be adjusted, but the peak of the carriages is diverse. There is always a specified peak difference or gap amongst the transportation car and the loading and unloading platform, which triggers the forklift to be unable to enter and exit the transportation vehicle to immediately load and unload the goods.
The little cell loading and unloading platform can offer a trustworthy connection with the truck, so that the forklift can safely and securely and rapidly enter and exit the transport vehicle for loading and unloading operating. The item has the characteristics of practical unloading, powerful balance and reduced maintenance cost, which is appropriate for numerous cars on loading and unloading websites andplaces with comparatively hefty targeted traffic.
|Optimum lifting peak||1.6m|
|Connection plate size||1530*650|
|Tyre||7 inch and 6 inch universal wheel|
|Handle||wi-fi remote manage
|Chassis||60*one hundred twenty*5 rectangle pipe
fifty*a hundred*3.75 rectangle pipe
|Xihu (West Lake) Dis.||14B# U-bar|
one. Go the mobile loading and unloading platform to the aspect of the vehicle or system that demands to load and unload goods, and make the side with the support roller near to the motor vehicle or platform.
two. Change the support roller of the loading and unloading platform and allow its height somewhat decrease than the height of the vehicle or platform.
three. Rotate the assistance outrigger to make it assistance the gear, and avoid the tools from moving by by itself. If the assistance outrigger is not supported well, the tools is strictly prohibited.
4. Use the aviation plug outfitted with the products to connect the electrical power line. For your protection, you should ensure that the equipment is reliably grounded.
(If 380V, we advise that you use nationwide common copper wire over 1.five sq. meters, if 220V, you would far better use countrywide normal copper wire over one.5 sq. meters.)
five. Up and down buttons on the distribution box can manage the ascending and descending motions of the table, or use the geared up remote management to do the identical operation.
6.When the equipment powers off or malfunction happens, the gear can be decreased to the cheapest level by way of the guide descent button on the facet of the pump station to make sure protection.
The 380V product might reverse the motor thanks to phase sequence, result the gear can’t increase up.Then we need to have to adjust the stage sequence.
1.When employing the system, connect the electrical power cable properly to prevent electrical components from burning out.
two. The assist bar must be reduced when the tools is doing work.
three. The load capability must not exceed the rated load, and the load must be evenly dispersed on the system surface area. Do bear in mind CZPT partial load.
four. The operator must know the functionality and the procedure procedure of the tools.
five. The temperature of operating environment is from- 10 ° to 50 °. 32# hydraulic oil is used in winter season and 46# hydraulic oil is utilized in summer. The oil need to be replaced if the tools is employed for more than one thousand hours or twelve months.
6. Before employing, please remember to verify no matter whether all the fixed areas are organization or not, whether or not the pipe link is trustworthy, whether or not the pipe is destroyed. To make confident that the electrical elements are doing work generally, the lubrication oil is enough in the guide way.
7. The system must be decreased to the least expensive place once concluded using.
8. The equipment has no water-proof purpose. Do not get wet in the rain when storing outdoors.